Microchip Debuggers & Programmers.

0.Contents

1.Microchip PICkit 4 In-Circuit Debugger.

 

Microchip PICkit 4 In-Circuit Debugger.

1.Microchip SNAP.

 

Microchip SNAP.

3.Configure PICkit 4 or SNAP.

  1. Launch MPLAB-IPE (Integrated Programming Environment).
  2. Select MCU Family, Select Device > Apply.
  3. Select MCU Family & Connect.
    Select MCU Family & Connect.
  4. If target board not powered go to :
    • Setting > Advanced Mode > Power > ICSP Options > Power Target Circuit from Tool.
    • Be sure Voltages are good for the target MCU.
  5. Connect PICkit 4 or SNAP to USB.
  6. Connect PICkit 4 or SNAP to ICSP connector on target board.
  7. MPLAB-IPE Select Tool : PICkit 4 or SNAP > Connect.
  8. Wait while downloading firmware into PICkit 4 or SNAP.
  9. Downloading firmware into PICkit 4.
    Downloading firmware into PICkit 4 or SNAP.

01.2020