Microchip Pre-requisites.

0.Contents

1.Microchip PICkit 3 In-Circuit Debugger.

Microchip PICkit 3 In-Circuit Debugger.

2.Configure PICkit 3.

  1. Launch MPLAB-IPE (Integrated Programming Environment).
  2. Select MCU Family, Select Device > Apply.
  3. Select MCU Family & Connect.
    Select MCU Family & Connect.
  4. If target board not powered go to :
    • Setting > Advanced Mode > Power > ICSP Options > Power Target Circuit from Tool.
    • Be sure Voltages are good for the target MCU.
  5. Connect PICkit 3 to USB.
  6. Connect PICkit 3 to ICSP connector on target board.
  7. MPLAB-IPE Select Tool : PICkit 3 > Connect.
  8. Wait while downloading firmware into PICkit 3.
  9. Downloading firmware into PICkit 3.
    Downloading firmware into PICkit 3.

09.2016